The process of using and installing light touch push button switches should require attention

Publish Time:2023-03-23 Author:jiaxi Views:1189

The process of using and installing light touch push button switches should require attention
 
　　1、When installing lighted light touch switches, you must be cautious. If looseness occurs during welding, you must reinforce it in time to avoid falling off.
 
　　2、When welding the switch twice in a row, the product should be dried to room temperature before welding again to avoid deformation of the material and easy dislodgement.
 
　　3、Be careful not to use washboard water.
 
　　4、When using the switch, be careful not to use too much force to avoid damage.
 
　　5、Try not to use destructively.
 
　　6、When using, try to press the center position, so as not to cause damage to the parts.
 
　　7、After installation, please contact after-sales maintenance for problems arising from the installation and welding process. Light touch push button switch supply
 
　　8、For the installation of corrosive gas materials generated during the welding process, the damage caused by the switch can also produce the danger of use, be sure to pay attention before use.
 
　　9、For models that are not airtight, foreign objects may enter the inside of the switch and easily cause a short circuit, please be sure to pay attention.
 
　　10、The last and most important point is to absolutely avoid touching the switch with wet hands. Unless it is a waterproof tact switch.